Entering Measurement Data:
To enter measurement data, start by creating an inspection, and navigate to the Inspection Summary page as shown below:
Screenshot: Inspection Summary Page
From this screen, there are three ways to enter data in the system:
1. "Spreadsheet / Matrix" view:
Click on the green "+ Measurements" button above the table to access the "spreadsheet / matrix" view as shown below:
Screenshot: Spreadsheet / Matrix View
2. Spec-by-Spec / Feature-by-Feature View
Alternatively, you can click on any row in the Inspection Summary table. For example, clicking on spec #8 on the inspection summary page takes you to the following page to capture data for spec #8. After capturing data for spec #8, you can navigate to the next spec by clicking "next" in the left-hand side menu.
3. Part-by-Part View
Finally, you can click on the "part view" icon in the left-hand sidebar to inspect your lot one piece at a time. This view will specs for a given part. You can click previous and next to navigate between part numbers. You can also highlight a part row on the spreadsheet view and then click "part view" to bring up the inspection page for that part.