Recording Gage IDs and Verifying Calibration During Inspection

To record the IDs of the gages used during an inspection:

1. Click on the "Gages" tab above the Inspection Summary table:

2. In the slide-out, you can enter the Gage ID for each feature, and 1factory will check to ensure the gage is in calibration. There are 3 possible outcomes:

1. Gage is "Ok to Use": In this case a green check mark appears, and the calibration date is auto-populated in the "Cal Exp Date" column
2. Gage is not found: In this case, a "?" appears, and the "Cal Exp Date" column is left empty
3. Gage is "Out of Cal": In this case, a red circle appears, and the calibration date (past due) is auto-populated in the "Cal Exp Date" column